One layer at the Butterfly Challenge

Challenge No. 10 at the Butterfly Challenge is One Layer. I decided to see whether I could recreate the card in my previous post in a one layer format. It involved a lot of masking! My base was a 7" x 7" blank card.

To begin with, I outlined the main image area very lightly with pencil, so that I could see where to place the masks. I used a waterproof masking film. The first ones went around the outside of the area so that I could stamp and clear emboss the grasses inside. With the masks still in place, I then sprinkled on some Brusho (this time sandstone rather than black, for a change), lightly sprayed it with water and blotted off the excess. The butterfly was then stamped with Versafine ink. As before, all stamps are by Chocolate Baroque.

I removed the outside masks and then masked the main panel instead. Next I stamped the grasses at the edge of the card. By this stage it was looking okay but a bit untidy where a bit of the Brusho had leaked under the mask. The final step was to draw the black frame around the main image with a drawing pen, which covered the untidy edges and pulled everything together.

Looking at the two cards side by side, I don't think this one is quite as crisp looking as the original version and I think I prefer the effect of the black Brusho rather than the sandstone. Perhaps brown ink rather than black would have gone better with the sandstone. However, given the limitations of the one layer format I was quite pleased with it, and it was an interesting exercise to try.